Nike FLOW

When creating a monitor, select Nike FLOW under Site Module.

• Sites: Select the Nike sites you want your monitor to watch for restocks on.

• Profile Group: Select the profile group you want your tasks to use.

• Profiles: Select the profiles you want your tasks to use.

• Proxy Group: Select the proxy group you want your checkout tasks to use when they are started.

Your proxies are not used until the product actually restocks and the tasks are created and started.

• Stop Tasks After: Enter the number of minutes you want your tasks to continue running after the most recent restock ping.

Sometimes products may continue restocking over time. If a product restocks again after your automation tasks have already started, the Stop Tasks After countdown will reset. Because of this, make sure to set a low stop time if needed.

• Min Size Loaded: Enter the minimum number of sizes that must be in stock before your tasks will start.

Sometimes a product may restock in only one size with very low stock throughout the day. To reduce how often your tasks are started, you can set a higher Min Size Loaded value so tasks only trigger when there is more substantial stock available.

• Product Quantity: Enter how many of the selected product you want to check out.

• Delete After Stop: Enable this if you want the tasks and task groups created by your automation to be deleted after they finish running following a restock.

• Local Monitor: Enable this if you want the monitor to check the site locally after it has been created. When enabled, the monitor will use the selected Proxy Group to monitor the site.

• Task Quantity: Enter the number of checkout tasks you want to be created.

Local Monitor: Enabling this can help pick up restocks faster, but it is not required. When enabled, the monitor will run locally using your selected proxy group. Do not use residential proxies with this setting, as it can quickly consume a large amount of proxy data.

After entering your desired settings, press Create to create the monitor.

Once a monitor is created you need to enter monitor inputs so Valor can look for the products you want